Plus U4-136 User Manual download pdf (Page 21)

E-20

Connecting Personal Computers and Video Equipment

To Output the External Output Signal of a Notebook Computer

When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook

computer startup procedure as well as the operation that follows notebook startup. Please consult the instruction manual of your

notebook computer or the on-line help while performing the following procedure.

Check whether a signal is being sent from the notebook computer to the projector.

An indication appearing on the liquid crystal display of the notebook computer does not necessarily mean that an external

output signal is being output.

REFERENCE: When “Resolution” or “Frequency” is not displayed under “Info.” on the menu of the projector, this means that

the external output signal is not being output from the personal computer. See “Resolution/Frequency” on Page E-59.

Should a sign not be output from the notebook computer, please try the operation described below.

For an IBM PC/AT compatible computer, press the [Fn] key plus any one of the [F1] to [F12] keys. (See the table below.)

Manufacturer Model Key

akia All computers Fn + F2

COMPAQ All computers Fn + F4

DELL All computers Fn + F8

EPSON All computers Fn + F8

FUJITSU All computers Fn + F10

GATEWAY All computers Fn + F3

iiyama All computers Fn + F3

IBM All computers Fn + F7

NEC All computers Fn + F3

Panasonic All computers Fn + F3

SHARP All computers Fn + F5

SONY All computers Fn + F7

SOTEC All computers Fn + F3

TOSHIBA All computers Fn + F5

Victor All computers Fn + F10

Note: Table information is current to September 2002.

Note:

When the liquid crystal display of the notebook computer and the projector are displayed at the same time, the projected image might not be

correct even though the liquid crystal display shows a correct indication. Should this occur, stop the simultaneous display of the notebook

computer and try the mode with external output only. Try an operation such as that described in aforementioned Step 2 and try closing the

liquid crystal panel which might result in external output only.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

No comments

Plus U4-136 User Manual Page 21